Produkter
Totalt antall treff i produkter:
Trykk for flere produkter.
No products were found.

Seachem PhosGuard - Removes Silicate and Phosphate

PhosGuard™

Removes silicate and phosphate

Spherical for optimal hydrodynamics

Irreversible binding

Les merShow less
From
kr 180.00
2-4 ukers leveringstid.
Størrelse
  • 250ml
  • 500ml
  • 1L
  • 2L
Bestillingsvare
Referanse:
186
Merke:
Ønskeliste
Beskrivelse

PhosGuard™ rapidly removes phosphate and silicate from marine and freshwater aquaria. Although PhosGuard™ is effective in both fresh and marine water, it will operate better in sea water and the need for it is better defined in sea water. It is not recommended for phosphate buffered freshwater (PhosGuard™ would remove the buffer until saturated). PhosGuard™ is highly porous and bead-shaped to promote easy water flow through and around it, thereby increasing both its efficiency and capacity.

Comparing Seachem Phosphate Removers

Product                                                      PO4 bound

PhosGuard (Alumina Oxide)                      0.87 mg/g

PhosBond (GFO and Alumina Oxide hybrid)      1.19 mg/g

PhosNet (GFO)                                              1.41 mg/g

Directions

May generate heat on initial contact with water. Pre-wet by adding to a double volume of freshwater, followed by a rinse. For best results, PhosGuard™ should be rinsed before use and placed so as to maximize the flow of water through it but not so that it tumbles against itself in flow. It may be used in a canister filter, media chamber, box filter, or any high flow area of a trickle filter. Use of a filter bag is recommended. Use 85 mL (1/3 cup) for every 200 L (50 US gallons) saltwater or 400 L (100 US gallons) freshwater.

Leave product in place for 4 days, then test phosphate or silicate concentrations with either MultiTest™ Phosphate or MultiTest™ Silicate. If the concentration of the component you are trying to decrease has not dropped to around 0.02 mg/L, then replace the PhosGuard™, otherwise leave in place until levels begin to climb again. As long as concentrations remain under control, the product is not exhausted. Over treating is not recommended. PhosGuard™ is not an exchange resin and does not release anything into the water. It does not leach phosphate or silicate back into the water and may be removed, dried, and returned to service until exhausted. Continuous use of small quantities is better than intermittent use of larger quantities.

Les merShow less
Produktdetaljer
186
Anmeldelser
Ingen kommentarer

Legg igjen en anmeldelse

  • Forventning:
  • Kvalitet:
Beskriv dette produktet ved bruk av enkle og korte ord.
Last opp bilder:
Slipp bilder her eller trykk for å velge.
Sist vist
3 andre produkter i samme kategori:

Meny

Innstillinger

Opprett en gratis konto for å lage ønskelister.

Logg inn