Produkter
Totalt antall treff i produkter:
Trykk for flere produkter.
No products were found.

Salifert kH/Alkalinity Test Kit

kr 120.00
På lager 2 Produkter
Referanse:
KHPT
Merke:
Ønskeliste
Beskrivelse

Calcium alone cannot form the skeletal material of corals and allow calcareous algae to grow. Some other substances are needed as well. A few other constituents are carbonate and bicarbonate. These two substances also have a major impact on the stabilization of the pH in the proper range of 8.1 – 8.4. Such stabilization is also called buffering.

The total carbonate and bicarbonate concentration is also called carbonate alkalinity or carbonate hardness. The only difference between alkalinity and carbonate hardness is a conversion factor.

NSW has an alkalinity of approx. 2.7 meq/L or approx. 7.5 dKH when expressed as carbonate hardness.

For a stable system the alkalinity or carbonate hardness should have a value similar to NSW or slightly higher and should preferably not fluctuate by more than 5%. This means a maximum fluctuation of 0.14 meq/L or 0.4 dKH.

Therefore an alkalinity test kit should be capable in measuring in steps smaller than 0.14 meq/L.

Conclusion: 

Since the major buffer components used for coral and calcareous algae growth are bicarbonate and carbonate, they should be added to correct any decrease in alkalinity or carbonate hardness.

A proper formulated buffer should function in such a way that the corrective measures results in a long lasting effect and should not upset the pH of the system. The alkalinity or carbonate hardness should be kept as stable as possible requiring highly sensitive and accurate means for testing.

The Salifert KH/Alk test is very straightforward. It measures in sufficient small steps of 0.1 meq/L or 0.3 dKH  with a sharp color change. This makes detection of important yet small change possible.

The kit can perform approx. 100 - 200 measurements.

Les merShow less
Produktdetaljer
KHPT
Anmeldelser
Ingen kommentarer

Legg igjen en anmeldelse

  • Forventning:
  • Kvalitet:
Beskriv dette produktet ved bruk av enkle og korte ord.
Last opp bilder:
Slipp bilder her eller trykk for å velge.
Sist vist
Kunder som kjøpte dette produktet kjøpte også:
På lager
From kr 300.00

Vennligst merk at PAR-måleren kan være utlånt til en annen akvarist når du bestiller denne tjenesten. Hvis dette er tilfelle, vil vi kontakte deg for å informere deg om når den vil være tilgjengelig for deg.

Du vil IKKE bli belastet noe før du mottar varen.

Bestillingsvare
kr 710.00

A TDS Meter measures the amount of Total Dissolved Solids (TDS) in a solution.

This measurement is used to determine the purity of the water produced by your RO unit and will give an indication of when your DI resin or membrane life is coming to an end. The inline version measures the TDS of the feed water before the RO Unit and the TDS of the pure water from the unit.

Since dissolved ionized solids like salts and minerals contribute to the conductivity of a solution, a TDS meter measures the conductivity of the solution which is then converted to a TDS reading.

TDS is directly related to quality of water i.e., the lower a TDS figure, the more pure the water. As an example, reverse osmosis purified water will have a TDS between 0 and 10, whereas tap water will vary between 20 and 300.

10 andre produkter i samme kategori:

Meny

Innstillinger

Opprett en gratis konto for å lage ønskelister.

Logg inn