Produkter
Totalt antall treff i produkter:
Trykk for flere produkter.
No products were found.

Seachem Reef Builder - Raises Carbonate Alkalinity (KH)

Reef Builder™

Raises carbonate alkalinity (KH) with minimal impact on pH

A blend of carbonate sources that will not lower pH as competing bicarbonate only products can

Will not deplete calcium, magnesium, or strontium

Les merShow less
From
kr 210.00
2-4 ukers leveringstid.
Størrelse
  • 300g
  • 600g
  • 1.2kg
Bestillingsvare
Referanse:
366
Merke:
Ønskeliste
Beskrivelse

Reef Builder™ raises carbonate alkalinity (KH) without immediately impacting on pH. With long term use there will be a tendency to stabilize at pH 8.3. Used as directed, Reef Builder™ will not deplete calcium, magnesium, or strontium which usually tend to precipitate with increasing alkalinity. Reef Builder™ and Reef Buffer™ may be used together. Use Reef Builder™ to raise carbonate alkalinity without affecting pH. Use Reef Buffer™ to raise carbonate alkalinity and pH. Reef alkalinity should be maintained at 3–5 meq/L (8–14 dKH). Alkalinity should not be allowed to fall below 2 meq/L.

Directions

Beginner

Use 3 g (1/2 level teaspoon) per 150 L (40 US gallons) twice a week. Dissolve in at least 250 mL (1 cup) of freshwater. Check alkalinity every 2 weeks and adjust amount or frequency accordingly. For precise dosing, use the Seachem Digital Spoon Scale.

Advanced

Check alkalinity (use MultiTest™ Marine pH & Alkalinity to test alkalinity levels), then follow addition regimen above until alkalinity is adjusted to 3-6 meq/L (8-17 dKH). Each 3 g/150 L will raise alkalinity by about 0.25 meq/L. Quantity or frequency can be adjusted, but do not exceed 12 g/150 L per day. Thereafter, use as required to maintain alkalinity.

Expert

After determining the alkalinity consumption rate, set up a continuous drip system. Use the following formula (or skip the math and use our Dosage Calculator) to determine how much to add to your top–off water: m=0.08va (m=grams to add to top off water, v=volume of tank in liters, a=amount to raise alkalinity in meq/L). For example, if you want to raise your alkalinity by 1 meq/L in a 200 liter tank, then you would add 0.08x200x1=16 g into the top–off water. [For reference: 1 gallon=3.8 liters, 6 g=1 teaspoon].

DO NOT OVERDOSE: Excess alkalinity may enhance the loss of calcium, magnesium, and strontium. Do not directly mix with any calcium, magnesium, or strontium supplement. Best if calcium & carbonate additives are added on alternate days or at least 30 minutes apart.

Les merShow less
Produktdetaljer
366
Anmeldelser
Ingen kommentarer

Legg igjen en anmeldelse

  • Forventning:
  • Kvalitet:
Beskriv dette produktet ved bruk av enkle og korte ord.
Last opp bilder:
Slipp bilder her eller trykk for å velge.
Sist vist
14 andre produkter i samme kategori:

Meny

Innstillinger

Opprett en gratis konto for å lage ønskelister.

Logg inn