Produkter
Totalt antall treff i produkter:
Trykk for flere produkter.
No products were found.

Seachem Reef Buffer - Raises pH to 8.3

Reef Buffer™

Raises pH to 8.3

Raises pH and carbonate alkalinity together

pK (8.6) allows for greater pH stability in a reef system where the bioload is significantly more than in a fish only system

Les merShow less
From
kr 210.00
2-4 ukers leveringstid.
Størrelse
  • 250g
  • 500g
Bestillingsvare
Referanse:
676
Merke:
Ønskeliste
Beskrivelse

When used as directed Reef Buffer™ will raise the pH of your reef system to 8.3 without fear of accidentally overshooting the pH to a dangerous level. Whereas competing products simply use sodium bicarbonate, Reef Buffer™ is made with a blend of carbonate and bicarbonate salts. This blend of salts results in Reef Buffer™ yielding a pK of roughly 8.6 in saltwater.

The pK of a buffering agent is equivalent to the pH around which that buffer most strongly buffers. One would presume, then, that the pK of a saltwater buffer should be 8.3; however, the multitude of organic acids produced by the inhabitants of a reef system forces pH downward to a much greater degree than in a non-reef, marine system. A buffer with a pK of 8.3 would end up yielding a pH more in the range of 8.0-8.2. Reef Buffer's™ higher pK (8.6) allows for greater pH stability in a reef system where the bioload is significantly more than in a fish only system. Competing products are not designed specifically for the reef environment, so their pK is too low (in most cases, pK 8.3). At this pK, the proper pH can never be reached in saltwater.

Reef Buffer™ will also raise carbonate alkalinity; however, when pH is not an issue, Reef Builder™ or Reef Carbonate™ should be your first choice for a carbonate alkalinity supplement.

Directions

Check pH and alkalinity before use (use MultiTest™ Marine pH & Alkalinity to test ph nd alkalinity levels). Use 5 g (1 level teaspoon) for every 150 L (40 US gallons) to raise pH by about 0.1 pH units (this will also raise alkalinity by about 0.5 meq/L). For precise dosing, use the Seachem Digital Spoon Scale. Dissolve in at least 250 mL (one cup) of freshwater, then add to the tank. The pH of natural sea water is 8.25–8.30. In a well established reef system pH adjustment may be necessary biweekly to semiweekly. Dosing requirements will vary, but do not exceed the recommended dose without checking your pH and alkalinity (alkalinity should not exceed 6 meq/L).

If an alkalinity of 6 meq/L has been reached and a pH of at least 8.20 has not been attained or substantial cloudiness that does not clear within 15 minutes is encountered, then the system is not ionically balanced. To restore ionic balance perform a water change or adjust the magnesium and calcium levels to approximately 3:1 Mg:Ca.

DO NOT OVERDOSE: Excess alkalinity may enhance the loss of calcium, magnesium, and strontium. Do not directly mix with any calcium, magnesium, or strontium supplement. Best if calcium & carbonate additives are added on alternate days or at least 30 minutes apart.

Les merShow less
Produktdetaljer
676
Anmeldelser
Ingen kommentarer

Legg igjen en anmeldelse

  • Forventning:
  • Kvalitet:
Beskriv dette produktet ved bruk av enkle og korte ord.
Last opp bilder:
Slipp bilder her eller trykk for å velge.
Sist vist
14 andre produkter i samme kategori:

Meny

Innstillinger

Opprett en gratis konto for å lage ønskelister.

Logg inn