Produkter
Totalt antall treff i produkter:
Trykk for flere produkter.
No products were found.

Seachem Reef Carbonate - Raises carbonate alkalinity (KH)

Reef Carbonate™

Raises carbonate alkalinity (KH)

Concentrated (4,000 meq/L)

Made with a blend of carbonate and bicarbonate salts

Les merShow less
From
kr 150.00
2-4 ukers leveringstid.
Størrelse
  • 250ml
  • 500ml
Bestillingsvare
Referanse:
666
Merke:
Ønskeliste
Beskrivelse

Reef Carbonate™ is a concentrated (4,000 meq/L) optimized blend of carbonate and bicarbonate salts designed to restore and maintain alkalinity in the reef aquarium. Calcium and carbonates are essential to all coral growth. If either becomes deficient, coral growth will cease, followed by a rapid decline in coral health. To prevent this you must provide carbonates (Reef Carbonate™) and calcium (Reef Advantage Calcium™ or Reef Complete®).

Whereas competing products simply use sodium bicarbonate, Reef Carbonate™ is made with a blend of carbonate and bicarbonate salts. This blend of salts results in Reef Carbonate™ yielding a pK of roughly 9.0 in saltwater (higher than competing products). In a closed reef system, the multitude of organics produced by reef inhabitants tends to force pH downward, but the advantage of Reef Carbonate’s™ higher pK is a stabilization of pH around 8.3-8.4. Competing products’ formulations make them incapable of such a claim, so pH will always fall below desirable levels for a reef aquarium.

Used as directed, Reef Carbonate™ will not deplete calcium, magnesium, or strontium which usually tend to precipitate with increasing alkalinity. Reef alkalinity should be maintained at 3–6 meq/L (8–17 dKH). Alkalinity should not be allowed to fall below 2 meq/L.

Directions

Beginner

Use 1 capful (5 mL) per 80 L (20 US gallons) twice a week. Best if diluted into a cup of freshwater, then added. Check alkalinity every 2 weeks and adjust amount or frequency accordingly.

Advanced

Check alkalinity (use MultiTest™ Marine pH & Alkalinity to test alkalinity levels), then follow addition regimen above until alkalinity is adjusted to 4–5 meq/L. Each mL contains a minimum of 4 meq of alkalinity. Each 5 mL/80 L will raise alkalinity by about 0.25 meq/L. Amount or frequency can be adjusted, but do not exceed 20 mL/80 L per day. Thereafter, use as required to maintain alkalinity.

Expert

After determining the alkalinity consumption rate, set up a continuous drip system. Use the following formula (or skip the math and use our Dosage Calculator) to determine how much to add to your top–off water: m=va/4 (m=mL of product to add to top off water, v=volume of tank in liters, a=amount to raise alkalinity in meq/L). For example, if you want to raise alkalinity by 1 meq/L in a 200 liter tank, then you would add (200x1)/4=50 mL into the top–off water. [For reference: 1 gallon=3.8 L].

Notes

Best to pour in gradually near strong water movement. Do not add to a sump or other area of slow water exchange. Use MultiTest:™ Marine pH & Alkalinity to measure total alkalinity or Reef Status™ Magnesium, Carbonate & Borate to measure carbonate alkalinity.

DO NOT OVERDOSE: Excess alkalinity may enhance the loss of calcium, magnesium, and strontium. Do not directly mix with any calcium, magnesium, or strontium supplement. Best if calcium & carbonate additives are added on alternate days or at least 30 minutes apart.

Les merShow less
Produktdetaljer
666
Anmeldelser
Ingen kommentarer

Legg igjen en anmeldelse

  • Forventning:
  • Kvalitet:
Beskriv dette produktet ved bruk av enkle og korte ord.
Last opp bilder:
Slipp bilder her eller trykk for å velge.
Sist vist
14 andre produkter i samme kategori:

Meny

Innstillinger

Opprett en gratis konto for å lage ønskelister.

Logg inn